Application purpose:
Tracing the location and routing of sub-surface pipework.

Using the table below, select the most appropriate camera model based on the following application level descriptions. Please also consider any limiting factors that may apply.

• Basic Applications include: Locating and routing central heating and hot water pipework to provide an understanding of the approximate locations.
• Intermediate Applications include: Locating and routing central heating and hot water pipework for the purposes of avoiding when drilling or carrying out intrusive works in close proximity.
• Advanced Applications include: Basic and Intermediate applications requiring high quality radiometric images for the purposes of analysing and presenting within a report.

Model	Basic	Intermediate	Advanced
FLIR E4
FLIR E5
FLIR E6
FLIR E8
FLIR E53
FLIR E54
FLIR E60
FLIR E75
FLIR T540
FLIR T640
FLIR T660
FLIR T865
FLIR T1020
FLIR T1030sc

Preparation/Environmental Conditions

Following a suitable amount of time with the heating off and the floor/walls cold, the heating/hot water should be turned on. The floor/walls should then be observed with a themal imaging camera until the location/routing of the sub-surface pipework becomes visible due to the variation in surface temperature on the floor/walls.

Limiting Factors to be considered

Water pipes within suspended floors, depth of pipes below floor, thick carpets/floor coverings will reduce heat transfer to the surface. In such circumstances, consideration should be given to selecting an increased specification camera which will have a greater chance of success.

Please note that the thermal imaging camera selection guidance above is intended as a guide only, Red Current Ltd will not be held accountable where the desired results do not meet preconceived expectations.